Post on 03-Jun-2018
8/12/2019 Tarjetas Chasis
http://slidepdf.com/reader/full/tarjetas-chasis 1/9
Tarjetas:
Linecard
Procesadora*
S P A
S h a r
e d P o
r t
A d a p
t e r
SIP
SPA Interface
Processor
S P A
S h a r
e d P o r t
A d a p
t e r
Procesadoras:
Modelo NombreCRS GRP / PRP
12000 GRP / PRP*10000 PRE*9000 RSP*7600 Supervisor7500 RSP6500 Supervisor
GRP Gigabit Router ProcessorPRP Performance Router Processor
PRE Processor Routing EngineRSP Route Switch Processor
Serie 12000
12004
The Cisco 12404 Internetrouter has a 5-slot cardcage which holds:•One RP, second RP option •Up to three line cards, twowith redundant RPs•CSF card
12006-12406•Route Processor (RP)— Slot 5 (bottom slot) is therecommended slot for thefirst RP. When the router isequipped with a redundantRP, it can be installed inany of the five regular linecard slots.•Line Cards— Up to fiveOC-192 line cards, four ifredundant RPs areinstalled. These slots arehot-swappable: A failedcard can be removed andreplaced with the router
powered on.
8/12/2019 Tarjetas Chasis
http://slidepdf.com/reader/full/tarjetas-chasis 2/9
12008• Two RPs • Two CSCs • As many as six Cisco12000 series line cards of
any type and anycombinationThe following sections
briefly describe the cardsthat you can use to populatethe upper cardcage.
12010-12410-12810Most Cisco 12010, Cisco12410, and Cisco 12810series routers field-replaceable units (FRUs)can be removed andreplaced with the power onand the system operating.This is known as onlineinsertion and removal(OIR). Power supplies, linecards, the RP, CSCs, SFCs,and alarm cards all supportOIR. Unless otherwisenoted, the maintenancetasks described in thischapter can be performedwhile the router remains
powered on.In some cases it may benecessary to power off therouter, for example, toupgrade both powersupplies and PDUs. Use thefollowing procedure to
power off the router.
8/12/2019 Tarjetas Chasis
http://slidepdf.com/reader/full/tarjetas-chasis 3/9
12012The RP must be installed inupper card cage slot 0. Ifyou have two RPs in yourCisco 12012, the second
RP must be installed in slot11 (from left to right). Thefactory configuration hasthe RP installed in slot 0.Line cards installed in theCisco 12012 support onlineinsertion and removal(OIR)
12016-12416-12816•Alarm— The far left slot isa dedicated slot for analarm card.•Slots 0 through 6— anyline cards supported by therouter.•Slot 7— The far right slotis reserved for the RP.•Slot 8— The far left slot isreserved for an optionalredundant RP.•Slots 9 through 15— Can
be populated with any linecards supported by therouter.•Alarm— The far right slotis a dedicated slot for analarm card.The Cisco 12000 seriesrouter supports onlineinsertion and removal(OIR), allowing you toremove and replace a card
while the router remains powered on.
8/12/2019 Tarjetas Chasis
http://slidepdf.com/reader/full/tarjetas-chasis 4/9
Serie 7500
7505The Cisco 7505 has fiveslots: four interface
processor slots and oneslot for the Route SwitchProcessor. The Cisco 7505supports 4 VIPs, one foreach interface processorslot.
7507The Cisco 7507 has sevenslots: interface processorslots 0 and 1, Route
Switch Processor slots 2and 3, and interface processor slots 4 through6. The Cisco 7507supports 5 VIPs, one foreach interface processorslot.
7513The Cisco 7513 has 13slots: interface processorslots 0 through 5, RouteSwitch Processor (RSP2,RSP4/4+, RSP8, orRSP16) slots 6 and 7, and
interface processor slots 8through 12. The Cisco7513 supports 11 VIPs,one for each interface
processor slot.
7576The backplane of theCisco 7576 has 13 slots.Router A uses interface
processor slots 0 through 5
8/12/2019 Tarjetas Chasis
http://slidepdf.com/reader/full/tarjetas-chasis 5/9
with a Route SwitchProcessor (RSP4/4+ orRSP8) in slot 6. Router Buses interface processorslots 8 through 12 with a
Route Switch Processor(RSP4/4+ or RSP8) in slot7. The Cisco 7576supports 10 VIPs, one foreach interface processorslot; 6 VIPs are supportedin Router A and 5 VIPsare supported in Router B.
Serie 6500
6503