Instrucciones WINAC RTX

download Instrucciones WINAC RTX

of 1

Transcript of Instrucciones WINAC RTX

  • 8/17/2019 Instrucciones WINAC RTX

    1/1

    Welcome.

    I found solution for runFULLY virtual WINAC RT into VMWARE 9 for developing andtesting enviroment.

    I have Vmware Workstation 9 and Win7 32 bit guest operating system. At Host WIN7 64 Bit.

    Let,s go:

    1.Create VM at hardware compatibility 9 Version. (1 processor with 2 cores , 1 Ethernet Bridged Network Adapter)

    2.In Vmware 9 VMX file You must add this lines (very important):

    ethernet0.virtualDev = "e1000e"bios440.filename="FUJITSU211_314.ROM"

    3.Copy into VM folder file from attachment (ROM FILE).

    4.Install WINAC RTX 2010 on OS

    5.In station configuration Add in slot IF1 IE General card . If You prompted to

    install drivers from RTX then accept this. From Guest OS this card was removed.Its normal don,t panic .

    6.Then From Step7 set IP addresfrom Menu --->PLC---->Edit Ethernet Node.

    7. Load program and use Fully virtualized WINAC.

    If You Have some problems To set IP from Edit Ethernet Node from STEP7 then Youcan retrive config from WLD file added into attachment. IP addres is 172.16.1.80.

    If You have further questions don't hesitate to contact me.

    Best regards.