Planos de Falsa Escuadra
Transcript of Planos de Falsa Escuadra
-
7/23/2019 Planos de Falsa Escuadra
1/6
Project: Sliding bevel square Page 1 of 6
Sliding bevel square
A sliding bevel square, which is an essential tool for marking out dovetails and other joints with angles, can be made on
the same lines as the try square . Again the dimension given are only for guidance.
http://www.craftsmanspace.com/ -
7/23/2019 Planos de Falsa Escuadra
2/6
Proje
Parts list
http://www.craftsmanspace.com/ -
7/23/2019 Planos de Falsa Escuadra
3/6
Proje
Assembly drawing
http://www.craftsmanspace.com/ -
7/23/2019 Planos de Falsa Escuadra
4/6
Proje
1. Stock
http://www.craftsmanspace.com/ -
7/23/2019 Planos de Falsa Escuadra
5/6
Proje
2. Straight Edge
http://www.craftsmanspace.com/ -
7/23/2019 Planos de Falsa Escuadra
6/6
Project: Sliding bevel square Page 6 of 6
Standard parts
Assemblage instructions
1. Mark a central point 20mm from the end of the stock and drill a D6mm hole. Fit the straight edge into the socket.
2. Pass the screw through this hole and the two washers and tighten the wing nut.
http://www.craftsmanspace.com/